Touch Up Car Paint Guide
Daytona Grey Pearl is not a “close enough” colour
Paint code LZ7S is the useful starting point for matching Audi Daytona Grey Pearl. Before touching the car, confirm the vehicle details and choose a repair format that suits the size of the damage.
Audi Daytona Grey Pearl (LZ7S) is best treated as a manufacturer formula rather than a colour you can judge reliably from a screen or a generic paint name. Small differences in finish, age and previous paintwork can make a visual match misleading.
Start with the code, then verify the car
The code LZ7S identifies the factory colour family used for Daytona Grey Pearl. It is still sensible to pair that code with the registration, model and year because manufacturers can revise formulas or use variants during production. If the panel has been repainted before, the existing finish may also differ slightly from the original factory specification.
| Item | What to use |
|---|---|
| Manufacturer | Audi |
| Colour | Daytona Grey Pearl |
| Reference code | LZ7S |
| Finish type | Pearl |
| Best first check | Vehicle paint lookup |
Choose the repair tool by the size of the damage
- Paint pen — useful for narrow chips, pin marks and fine scratches where control matters most.
- Brush bottle — better when a chip is wider or irregular and needs a little more paint laid into the damaged area.
- Colour-matched aerosol — suited to scuffs or larger local areas where a spray pattern will blend more naturally than a brush mark.
Repairing Daytona Grey Pearl without building a thick blob
- Wash the panel and remove wax, silicone and traffic film from the repair area.
- Inspect the chip. If bare metal or plastic is exposed, use the correct primer only where it is required.
- Apply colour in thin stages. A small repair normally looks better when the paint is built gradually instead of filled in one heavy coat.
- Allow the colour layer to flash and dry in line with the product instructions.
- If the paint system requires clear coat, apply it only after the colour has been laid down correctly.
- Leave the repair to harden before polishing. Trying to level soft paint usually makes the edge worse.
Pearl colours need more control than a simple solid shade
Pearl systems can use an effect layer above the base colour. The number and thickness of effect coats can change the final appearance, so a tiny touch-up is usually approached differently from a full panel repair.
Common causes of a visible repair
- Ordering from the colour name rather than confirming the code.
- Applying too much paint in one pass.
- Painting over polish, wax or silicone contamination.
- Trying to sand or polish the repair before it has fully hardened.
- Expecting a tiny local repair to behave exactly like a professionally refinished full panel.
Audi Daytona Grey Pearl FAQ
Is LZ7S the paint code for Daytona Grey Pearl?
It is a recognised reference for Audi Daytona Grey Pearl, but always verify it against the vehicle before ordering because production variants and previous repairs can affect matching.
Do I need lacquer over the colour?
That depends on the paint system and the product you are using. If the repair uses a basecoat system, a clear protective layer is normally required. See the application guide for the product sequence.
Can I repair a stone chip without spraying the whole panel?
Yes. Small isolated chips are exactly the type of damage touch-up products are intended for, provided corrosion or widespread clear-coat failure is not present.
Need paint for a small repair? Start with the Touch Up Car Paint vehicle lookup so the colour can be identified from the vehicle details before you choose a pen, bottle or aerosol.
